One thing I love is versatility. Many presser feet are very versatile and one of these is the blind-hem foot. If you have an adjustable blind hem foot that is even better, but I have a fixed one. It came with my Brother XR6600. I have 5 uses for it including, of course, blind-hemming. The rest will be covered in the following posts and they are: pin-tucking, edge-stitching/top-stitching, stitching-in-the-ditch, and edge-joining.
Before you begin, you must attach your blind-hem foot. Yours may look a little different and may be adjustable, but this is mine. At the front you can see that it has a metal guide which goes underneath the foot, kinks in the middle for the needle, and then goes back to its regular path.
Use 1: Blind-hemming
When you blind hem by machine, it is not always absolutely invisible — that is why I usually hem by hand. You will get instead, a little ladder stitch along the stitching line.
To begin, neaten the raw edge and then turn up the hem. (Photo at left.) Then fold it back on itself so that you have a sort of tuck on the RS and the neatened edge is pointing away from the garment. (Photo at right.)
Select the blind-hem stitch (number 9 below) on your machine, or the stretch blind-hem stitch (number 10 below) if you are using stretch fabric like jersey.
You may need to adjust the stitch width on your machine if you can to make sure the needle catches the fabric on the zigzag swing of the stitch. Secure the stitch or leave long thread tails to hand tie. Holding the thread tails neatly out of the way, start stitching. Keep the fold of the fabric butted up against the metal guide on the foot. When you get to the end, secure the stitch or leave long thread tails to tie.